GE 0150-0255C User Manual

Page of 54
Kalatel VDR 
1-4 
0150-0255C 
RS-232 Serial Port 
Use a Null Modem cable when connecting to a 
PC.  When connecting to a multiplexer, it may 
be necessary to construct a cable using the pin-
out documentation of the MUX as a guide.  See 
the pin-out configuration for the VDR below. 
Connector Type:  DB-9 
Gender (on unit):  Male 
Cable Required (Connected to PC):  Null Modem 
Cable Required (Connected to Multiplexer):  
Variable, depending on pin-out configuration of 
MUX. 
DB-9 Pin Configuration for Serial Port 
Pin 
Use 
 
Pin 
Use 
 
Pin 
Use 
DCD 
 
Not Connected 
 
RTS 
RX 
 
Ground 
 
CTS 
TX 
 
Not Connected 
 
Not Connected 
RS-232 
1
5
6
9
 
DB-9 Connector on 
Back Panel 
1.8  Accessories I/O Port 
The back panel of the unit is equipped with an Accessories Port (DB-9 style connector) for 
connecting peripheral devices such as alarm devices, alarm relays, or the VEXT connection. 
Do not attempt to wire accessories directly to the DB-9 connector. 
Pin 
Use 
 
Pin 
Use 
 
Pin 
Use 
Alarm In 
 
Alarm Record 
Reset 
 
Ground 
Alarm Out   
VEXT Pulse 
Out 
 
Videoloss Out 
Record 
Start In 
 
Error Out 
 
Disk End Out 
I/O 
1
5
6
9
 
DB-9 Connector on 
Back Panel 
 
Alarm In 
An alarm condition can be activated by an Active Low TTL input 
or by relay contact devices such as pressure pads, passive 
infrareds, door switches, or other similar devices. 
Input: Active Low TTL w/ pull-ups 
or Normally Open Relay. 
High: 5V (12V tolerant) 
Low: Ground 
Minimum Duration: 0.5 Seconds 
 
Figure 1-4 Normally Open Relay Alarm Connection 
Pin 1
Pin 7 or 10
A l a r m   I n p u t
G r o u n d
A c c e s s o r i e s   P C B
T y p i c a l   A l a r m   D e v i c e
R e f e r   t o   e a c h   a l a r m   d e v i c e s ' s
m a n u a l   f o r   s p e c i f i c   w i r i n g   d e t a i l s .
N o r m a l l y   O p e n
( C l o s e s   D u r i n g   A l a r m )