A&D SK-5001WP User Manual

 

- 4 - 

 

WEIGHING 

Before Weighing 

Automatic Power-Off Function. 

 

  If the scale is left ON and the stable indicator is displayed, the automatic 

power-off function turns the power off after approximately five minutes 
(factory setting). To disable or enable the function, press the [ON/OFF] 
key while pressing the [RE-ZERO] key. The scale stores this setting. To 
verify this, press both the [RE-ZERO] and [UNITS] keys while in the 
weighing mode. (See "CALIBRATION" about the [UNITS] key.) 

 

  poff0   Function disabled  

poff1   Function enabled 

Error Message 

 

      e     Overload 

 

   -----

 

  The scale zero is out of range 

 

     lb      Low battery 

Calibration May be Required Before Weighing 

 

  Read “CALIBRATION” first and if necessary, calibrate your scale for 

accurate weighing. 

 

Weighing Procedures 

 

  Press the [ON/OFF] key to turn on the scale. Then the scale displays 

all segments for a few seconds and then    0   will be displayed. 

 
 2. 

 

  Press the [RE-ZERO] key to display    0 . Verify the reading is    0 . 

 

  Place objects on the weighing platform to weigh. 

 

  When the reading becomes stable, the stable indicator

 

 is displayed. 

 

  Place an empty container on the platform. 

 

  Wait for the stable indicator

 

 to be displayed and press the 

[RE-ZERO] key. Place the objects to be weighed in the container. When 

the reading becomes stable, the stable indicator

 

 is displayed. 

 

  If you use the (k)g-lb model, press the [UNITS] key to select 

weighing with either (k)g or lb as the unit. 

 

  Normally scales power up in lb when shipped from the factory. To 

power up in (k)g, turn the scale off. Press and hold the [UNITS] key, 

then press the [ON/OFF] key. The scale will start with (k)g. To return 

to the original setting, repeat this instruction.