Panasonic AJ-D750P User Manual

After this system has been connected, the video output signal (ENCODER OUT) must be
adjusted if AB roll editing (editing using two source machines) using an editor, for instance,
is to be error-free and accurate. (This adjustment must be repeated when one of the
connecting cables has been replaced and whenever the connections are changed.)

The adjustment procedure using this unit is outlined below.

Check the connections. (see page 22.)

Set the REMOTE/LOCAL switch

on the front panel bottom section to the adjustment

p o s i t i o n   ( L O C A L ) .
REMOTE:  For adjusting the video output signals using an external encoder remote

controller.

For adjusting the video output signals using this unit.

Adjust the source machine independently.

When using the preset values

Set the PRESET/MANUAL switches of the VIDEO LEVEL, CHROMA LEVEL,
SETUP and HUE controls to PRESET.

When adjusting the video output signals without using the preset values

1 Play back a cassette tape on which standard color bar signals have been

recorded.

2  Adjust the controls in such a way that the waveforms on the waveform

monitor (WFM) and vectorscope (VSC) resemble those shown in the figures
below.

Video level
Adjust this level to 100IRE.

Adjust the two controls in such a way that the light spot of the
vector waveforms comes inside the rectangular grid mark.

Setup level
Adjust the control to eliminate deviation.

Perform the same adjustments on the source machine connected to the unit.

- 4 1 -