Philips LTC 3962 User Manual
8
PHILIPS LTC3924/62 (E) QR34071
43. VIDEO IN
Receives video signal from a video camera or another
VCR.
VCR.
44. VIDEO OUT
For connection to monitor.
45. EXTERNAL INTERFACE (8 X 2-PIN) JACK
Connect an alarm switch, door sensor, etc.
q ALARM IN
w ALARM OUT
e NC
r TAPE END OUT
t TAPE END RESET
y NC
u NC
i TIME ADJUST
o CAMERA SW OUT
!0 REC START IN
!1 NC
!2 NC
!3
!4 NC
!5 GND
!6 GND
w ALARM OUT
e NC
r TAPE END OUT
t TAPE END RESET
y NC
u NC
i TIME ADJUST
o CAMERA SW OUT
!0 REC START IN
!1 NC
!2 NC
!3
!4 NC
!5 GND
!6 GND
[REAR]
43 44
46
45
47
6
1
5
1
4
1
3
1
2
1
1
1
0
1
9
8
6
7
5
4
3
2
1
46. AUDIO IN
Accepts an audio signal from a camera, external
sound equipment or another recorder (Line: –8 dBm,
50 kohm, unbalanced).
sound equipment or another recorder (Line: –8 dBm,
50 kohm, unbalanced).
47. AUDIO OUT
Provides an audio output for a monitor or another
recorder (–9 dBm, 600 ohm, unbalanced).
recorder (–9 dBm, 600 ohm, unbalanced).
Screwdriver
Tab
Wire
10mm
CONNECTING WIRES
1. Strip off the wire cover by approx. 10mm.
2. Use a screwdriver, etc. to hold the tab, then
1. Strip off the wire cover by approx. 10mm.
2. Use a screwdriver, etc. to hold the tab, then
insert the wire.
• Push the tab firmly when inserting wire.
• Push the tab firmly when inserting wire.
3. Release the screwdriver.
• The wire will be fixed.
Note: When disconnecting the wire, use the screw-
driver again to hold the tab, then pull the wire out.
driver again to hold the tab, then pull the wire out.