Hasbro 02011 Leaflet

This device complies with Part 15 of the 
FCC Rules. Operation is subject to the 
following two conditions: 
(1) This device may not cause harmful 

interference, and 

(2) This device must accept any interference 

received, including interference that may 
cause undesired operation.

WARNING: Changes or modifications to 

this unit not expressly approved by the party 
responsible for compliance could void the 
user's authority to operate the equipment.
NOTE: This equipment has been tested 

and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed 
to provide reasonable protection against 
harmful interference in a residential 
installation. This equipment generates, uses 
and can radiate radio frequency energy 
and, if not installed and used in accordance 
with the instructions, may cause harmful 
interference to radio communications.
However, there is no guarantee that 
interference will not occur in a particular 
installation. If this equipment does cause 
harmful interference to radio or television 
reception, which can be determined by 
turning the equipment off and on, the 
user is encouraged to try to correct the 
interference by one or more of the 
following measures:
-  Reorient or relocate the receiving antenna.
-  Increase the separation between the 

equipment and receiver.

-  Connect the equipment into an outlet on 

a circuit different from that to which the 
receiver is needed.

-  Consult the dealer or an experienced 

radio/TV technician for help.

1. Your Micro Personal Player 

comes with batteries already installed.

2. To replace batteries, 

unscrew battery door lock.

3. Remove exhausted batteries 

and dispose of properly.

4. Insert 3 new LR44/G13A 

type Button Batteries.

5. Replace battery door and 

tighten screw.

Slide Music 
Clip Single 

into player.

Carefully 
place earplug 
into ear.

Press the 
Play button 

to start and 
stop music.

- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon zinc), or 

rechargeable batteries (nickel-cadmium).

- Battery installation should be done by an adult.
- Non-rechargeable batteries are not to be 

recharged.

- Rechargeable batteries are to be removed from 

the toy before being recharged (if removable).

- Rechargeable batteries are only to be charged 

under adult supervision (if removable).

- Only batteries of the same or equivalent type 

as recommended are to be used.

- Batteries are to be inserted with correct polarity.
- Exhausted batteries are to be removed from 

the toy.

- The supply terminals are not to be short-circuited.
- Do not dispose of batteries in fire, batteries may 

explode or leak.

®