Accusplit 1520M2 Leaflet

While gently holding the belt clip open, slide the pedometer 

onto your belt or the top edge of your pants or skirt. It should fit 

snugly and level, above one knee. 

 The pedometer should be as vertical as possible. Walkers 

with larger stomachs may find it helpful to wear the pedometer 

farther back on the body, toward one hip. 

The cover must be closed for the pedometer to work. To 

avoid losing or dropping your pedometer, use the included leash 

and clip to fasten the pedometer securely to your clothing. 

Attaching the Leash: Attach the pedometer to the leash by 

looping the leash around the pedometer belt clip. Next, loop the 

leash through the enclosed plastic clip, then clasp the waistband 

of your clothing with the clip. You can also use a safety pin to 

fasten the leash to your clothing, loop the leash through your 

belt or belt loop or use a badge holder. 

Once you put on your pedometer with the cover closed, it will 

automatically begin to record your steps. Repeatedly press the 

yellow MODE button to cycle through the pedometer modes:

DAILY STEPS→TOTAL STEPS→DAILY STEPS

ACCUSPLIT, Inc.  •  2290M Ringwood Ave.  •  San Jose, CA 95131

800-965-2008  •  925-226-0888  •  FAX 925-463-0147 •   www.ACCUSPLIT.com   •  support@ACCUSPLIT.com

ACCUSPLIT®
       EAGLE

™

 

Congratulations on taking the first step to wellness with your purchase of an 

ACCUSPLIT pedometer. It’s easy to set up your new pedometer. 

Just follow the steps below, and start walking!

Most people prefer to reset step counts daily. To reset: While 

displaying Day’s STEPs, press and hold MODE button for at  

least three seconds to reset to zero. When displaying Total  

STEPs, press MODE button for three seconds to reset Total and 

Day’s STEPs to zero.

1. To filter out random movements, the unit remains in standby  

  mode until 5 continuous steps are registered. Only then are  

  the 5 steps calculated in, and an Active indicator “▲” appears  

  on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds the  

  timer pauses and the unit switches to standby status (Active  

  indicator “▲” disappears). 

When the display starts to dim or goes blank, it is time to replace 

the battery. Your pedometer uses one Type LR44 1.5 volt alkaline 

battery. To replace:

1. Insert a coin into the slot on the bottom of the case, and twist  

  counterclockwise to loosen the case front. Lift case front away.
2. Using a pen or other thin object, push battery sideways out of  

  its holder. Replace it with a new battery. The battery’s positive (+)  

  terminal should be FACE UP while you put it into the pedometer.
3. Align case front over the pedometer and press gently to snap  

  cover back into place, starting with top.

ACCUSPLIT

 EAGLE

AccuSTEP

99

970-044

(Badge holder not included)

REGISTER NOW 

Please return 

your 1520M2 Registration to the 
Repair Center address in the 
warranty, and we will let you 
know about future products. 

Email (preferred)
User

See label inside the lid of the pedometer.

DISPLAY MODES
•   “D”– “Day’s Step

s

”

  Counts steps taken since last ReSet. Reset daily  

  to count each day’s steps.

•  “t”–”total StepS”

  Keeps track of all steps taken, even after Day’s  

  Step

s

 are reset.