DCS dCS 904 User Manual
dCS 904 User Manual
Manual for Software Version 1.5x and 1.36
dCS Ltd
June 2000
Manual part no: DOC135904 iss 2B2
Page 11
135904ma2b2.pdf file available from website
Contact
dCS
on + 44 1799 531 999
email to: more@dcsltd.co.uk
(inside the UK replace + 44 with 0)
web site: www.dcsltd.co.uk
SDIF/DSD Clk In
BNC
SDIF/DSD Clk Out
BNC
This pair take in and give out Word Clock, and can be set to Bit Clock for DSD.
The functions are set by the menu. Clock In is terminated and Clock Out is
regenerated internally, so these lines can be used for daisy chaining many units
together, without loading problems. See
The functions are set by the menu. Clock In is terminated and Clock Out is
regenerated internally, so these lines can be used for daisy chaining many units
together, without loading problems. See
for the time
alignment of these signals.
Remote In & Out
9 pin D type male (2 off)
If the Windows™ Remote software is in use, connecting Remote In to a com
port (RS-232 port) on a PC running the Remote Control program allows the unit
to be controlled by the PC. Remote Out may be connected to another suitably
equipped dCS unit, allowing several units to controlled by the same PC with one
RS-232 daisy chain. In addition, the unit may be software upgraded without
removing the lid by downloading new software via the Remote In port – see
port (RS-232 port) on a PC running the Remote Control program allows the unit
to be controlled by the PC. Remote Out may be connected to another suitably
equipped dCS unit, allowing several units to controlled by the same PC with one
RS-232 daisy chain. In addition, the unit may be software upgraded without
removing the lid by downloading new software via the Remote In port – see
Connect up Remote ports using a 9-way screened cable, fitted with 9-way ‘D’-
type connectors at each end, wired pin 1 to pin 1, pin 2 to pin 2, etc. The same
type of cable can be used unit to units as com port to first unit. Suitable cables
are available from dCS.
type connectors at each end, wired pin 1 to pin 1, pin 2 to pin 2, etc. The same
type of cable can be used unit to units as com port to first unit. Suitable cables
are available from dCS.
Mains Supply
3 pin IEC (CEE22)
Switched, fused and filtered IEC mains connector.
Additional Information
-
As well as connectors, the rear panel displays the following information about
the unit, near the mains supply connector:
the unit, near the mains supply connector:
Mains Voltage
The actual voltage setting supplied.
Model Number
dCS 904
Manufacturers Name and Country of origin (dCS Ltd, UK)
Serial Number
-
The underside of the unit will have a label on that contains a number such as
904 4B1 6B2 2A1 3A2 12345. This is the serial number, but it also contains vital
configuration information. We will need this number (all of it) to give you support
over the phone, or to ship you software updates.
904 4B1 6B2 2A1 3A2 12345. This is the serial number, but it also contains vital
configuration information. We will need this number (all of it) to give you support
over the phone, or to ship you software updates.