Panasonic LSQT1060 User Manual

Getting Start

Requires two AA batteries (supplied).

. Install batteries in the battery compartment.

• Battery polarity (+) and (-) must match the markings

inside the compartment.

Two AA size

Remote Control Battery Installation

. Slide the battery cover in direction of arrow.

. Slide the battery cover until it snaps shut.

Incorrect battery installation can cause the batteries to
leak, leading to personal injury and/or damage to the
Remote Control.
Observe the following precautions:
1.  Always replace batteries with a pair of new ones.
2.  Do not combine a new battery with an old one.
3.  Do not mix battery types (example: “Zinc Carbon”

with “Alkaline”).

4. Do not attempt to charge, short-circuit, disassemble,

heat or burn used batteries.

5. Battery replacement is necessary when the Remote

Control acts sporadically or stops operating the
Projection Display set.

Helpful Hints:

(1) Frequent Remote Control users, choose

long-lasting Alkaline batteries as replacements.

(2) Whenever batteries are removed, you may need

to reset Remote Control infrared codes.
We suggest making a note of the codes on
page 58 prior to setting up the remote.

Reset All Memory Functions

Use when moving unit to a new location, or when First
Time Setup needs to be done over.

Press together the VOL- button
on the unit and OK button on the
Remote Control for more than
3 seconds. Unit shuts itself off when
reset is done.

• POWER indicator flashes red. After

flashing stops, unplug the unit then
plug it back in and turn power ON.

CAUTION

Note:

• When using “Control with HDMI (HDAVI Control)”, with the

device connected, set “Ctrl with HDMI” first to “Off” and then
“On” using the Setup Menu. (p. 56)