Manualsbrain.com
  1. Manuals
  2. Brands
  3. Adtran
  4. 616
  5. User Manual

Adtran 616 User Manual

Download
Page of 264
Total Access 600 Series System Manual
Section 4  User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
181
.
2. Configuring the Layer 2 Protocol
For more details on the configuration parameters discussed in this section, refer to the following pages:
Layer 2 ATM Network Interface Protocol menus beginning on 
Ethernet Interface Setup Instructions 
Most applications should not require a manual setup for the Ethernet interface. By 
default, the Ethernet interface is configured to auto-detect the data rate (as either 10 
or 100 Mbps). The following steps disable the auto-negotiation parameter and 
manually configure the interface.
Step
Action
1
From the main menu, select I
NTERFACES
.
2
Highlight the C
ONFIG
 menu for the ETH interface and press <E
NTER
>.
3
Use the right arrow to select A
UTONEGOTIATION
 and press <E
NTER
>. Use the 
down arrow to choose OFF.
4
Select the D
ATA
 R
ATE
 field and specify either 10B
ASE
T or 100B
ASE
T.
5
Select the D
UPLEX
 T
YPE
 field and specify either H
ALF
 D
UPLEX
 or F
ULL
 D
UPLEX
.
Layer 2 Protocol (ATM) Configuration – T1 Interface  
Step
Action
1
From the main menu, select L2 P
ROTOCOL
 and press <E
NTER
>.
2
Use the arrow keys to select the P
ROTOCOL
 field for the T1 interface. Press 
<E
NTER
>. Select ATM from the list of available protocols.
3
Use the arrow keys to select the C
ONFIG
 menu for the T1 interface and press 
<E
NTER
>.
4
Highlight the ATM C
ONFIG
 menu for the T1 interface and press <E
NTER
>.
5
Enter the I
DLE
 C
ELLS
 format for your network.
6
Set D
ATA
 S
CRAMBLING
 appropriately for your network.
7
Back all the way out to one level to the PVC C
ONFIG
 menu, and press <E
NTER
>. 
Enter the VPI and VCI values for communicating with that Gateway. Select 
R
OUTER
 under the C
ONNECTION
 field.
8
Select the S
ETUP
 menu and configure the virtual circuit for IP or PPP operation.