Vidikron 85 User Manual
14
Vidikron Vision 85 Owner’s Operating Manual
PRE
L
IMINAR
Y
2.6
Vision 85 Built-In Keypad
Vision 85 Built-In Keypad
The Vision 85 has a built-in keypad that you can use to access the menu system for working
with digital 1080i or 1080p sources. Figure 2-6 shows the Vision 85 built-in keypad; the
paragraphs that follow describe its use.
with digital 1080i or 1080p sources. Figure 2-6 shows the Vision 85 built-in keypad; the
paragraphs that follow describe its use.
Figure 2-6. Vision 85 Built-In Keypad
1.
RETURN
Press RETURN to exit the current menu or cancel an operation.
2.
ENTER
Press ENTER to confirm a menu item selection.
3.
DOWN / UP / LEFT / RIGHT
Use these buttons to select menu items or adjust settings.
4.
MENU
Press MENU to display or hide the OSD menus for digital 1080i or 1080p sources.
5.
(not used)
6.
STANDBY
Press STANDBY to put the projector into standby mode.
7.
ON
Press ON to turn the projector on or off.
Only trained service personnel should use the built-in keypad.
Almost all projector configuration and operational tasks can be
performed using the VHD Controller.
Almost all projector configuration and operational tasks can be
performed using the VHD Controller.
It is only necessary to use the built-in keypad if IR signals from the remote
control cannot reach the VHD Controller, or for performing
service-related tasks such as resetting the lamp hour counter (refer to
Lamp Replacement on page 63).
control cannot reach the VHD Controller, or for performing
service-related tasks such as resetting the lamp hour counter (refer to
Lamp Replacement on page 63).
RETURN
ENTER
DOWN
UP
LEFT
RIGHT
RETURN
ENTER
DOWN
UP
LEFT
RIGHT
ON
ON
MENU
MENU
ASPECT
RATIO
ASPECT
RATIO
STANDBY
STANDBY
1
3
4
5
2
7
6
Note