Vidikron 85 User Manual
42
Vidikron Vision 85 Owner’s Operating Manual
PRE
L
IMINAR
Y
Attach Lens Mounting Assembly to Lens Motor Carriage Plate:
1.
Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the Anamorphic
Lens Holder (item #5).
Lens Holder (item #5).
2.
Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate (item #7).
Position the bracket so that the long slot at the bottom of the lens holder is
perpendicular to the corresponding slots on the carriage plate.
Position the bracket so that the long slot at the bottom of the lens holder is
perpendicular to the corresponding slots on the carriage plate.
3.
Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers (item #6)
and Yaw/X Adjustment Levers that you removed in Step 1.
and Yaw/X Adjustment Levers that you removed in Step 1.
4.
Use the Lens Mounting Screws to attach the Lens Adapter Ring (item #1) to the Pitch
Adjustment Yoke (item #2); see Figure 3-22. (Use the round, threaded holes on the yoke.)
Adjustment Yoke (item #2); see Figure 3-22. (Use the round, threaded holes on the yoke.)
5.
Use the Height/Y Adjustment T-Screws (item #3), Pitch Adjustment T-Screws (item #4)
and T-Nuts (item #9) to attach the Pitch Adjustment Yoke and Lens Adapter Ring to the
Anamorphic Lens Holder. The Yoke should be as close to the primary lens as possible.
and T-Nuts (item #9) to attach the Pitch Adjustment Yoke and Lens Adapter Ring to the
Anamorphic Lens Holder. The Yoke should be as close to the primary lens as possible.
6.
Attach the lens to the Lens Adapter Ring by threading it clockwise.
Figure 3-22. Attaching the Anamorphic Lens to the Lens Adapter Ring
Lens threads into ring
FO
CU
S