Vidikron 85 User Manual
Vidikron Vision 85 Owner’s Operating Manual
71
PRE
L
IMINAR
Y
HDMI Black Level: This control compensates for incoming elevated black levels present in
certain video signals. When you set it to Auto, the Vision 85 automatically determines the
best setting according to the incoming video signal type. For some types of video, you may
want to override the setting. Set it to 0 IRE if blacks appear elevated (dark gray). If blacks
appear “crushed” (too dark), set it to 7 IRE.
certain video signals. When you set it to Auto, the Vision 85 automatically determines the
best setting according to the incoming video signal type. For some types of video, you may
want to override the setting. Set it to 0 IRE if blacks appear elevated (dark gray). If blacks
appear “crushed” (too dark), set it to 7 IRE.
or
to select the image background – solid blue, solid black or the Vidikron/ISF logo welcome
screen. The Splash Screen Color appears when you turn on the projector.
screen. The Splash Screen Color appears when you turn on the projector.
Power Save: Select Power Save from the Options menu to access the power management
features of the Vision 85.
features of the Vision 85.
• RS-232C Port: When this option is set to On, the RS-232 port is always active and using
power, even when the projector is in standby mode. When set to Off, the RS-232 port is
inactive and does not consume power when the projector is in standby mode.
inactive and does not consume power when the projector is in standby mode.
• Auto Power Off: When this option is set to On, the projector enters standby mode after
15 minutes of inactivity (no input signal). Five minutes before this is to occur, the message
“Enter STANDBY mode in 5 min.” appears on-screen. This message updates to indicate the
amount of time before the projector enters standby mode.
“Enter STANDBY mode in 5 min.” appears on-screen. This message updates to indicate the
amount of time before the projector enters standby mode.
When set to Off, the projector remains in the “power on” state regardless of the presence
or absence of an input signal.
or absence of an input signal.
Baud Rate: Select Baud Rate from the Options menu, then press the
or
button to
change the data rate of the RS-232 connection between the projector and the VHD
Controller. The default setting is 9600 bps. Do not change it unless specifically instructed
to do so by Vidikron Technical Support.
Controller. The default setting is 9600 bps. Do not change it unless specifically instructed
to do so by Vidikron Technical Support.
Fan Mode: If the projector is being used in a high-altitude environment, use the Fan Mode
control to prevent it from overheating. Set it to High Altitude (2) to run the fan at high speed;
set it to Normal (1) to run the fan at normal speed.
control to prevent it from overheating. Set it to High Altitude (2) to run the fan at high speed;
set it to Normal (1) to run the fan at normal speed.
Factory Default: To reset all projector settings (including image settings) back to their
factory defaults, choose Factory Default from the Options menu. When the confirmation
message appears, select Yes to perform the reset or No to cancel. This action is not
undoable. Proceed with caution!
factory defaults, choose Factory Default from the Options menu. When the confirmation
message appears, select Yes to perform the reset or No to cancel. This action is not
undoable. Proceed with caution!
Always set this option to On. Doing otherwise may disrupt
communication between the projector and VHD Controller.
communication between the projector and VHD Controller.
When you set the Auto Power Off function to Off, the LED function (refer to
4-70) is automatically set to On.
4-70) is automatically set to On.
The Factory Default command does not reset the Lamp Timer or OSD
Language setting.
Language setting.
Caution
Note
Note