Speco Technologies 16TH User Manual

User’s Manual

DVR-4TH/8TH/16TH Series

SPECO TECHNOLOGIES 07/10

118

5.8.1

Load Factory Default

This item is used to load the factory default setting. Select <Yes> to recall the
factory default setup configuration from the “read-only” memory, or select
<No> to cancel.

5.8.2

Import Configuration

This item allows the user to load a unit configuration that was saved on an
external drive. To import a configuration that was previously exported, make
sure the device that saved the configuration is connected to the unit. Select
<Import Config> from the Configuration menu and press ENTER. The
following menu is displayed.

Import Config

Config Name
xxxx-xxxx
xxx-xx

Select

No
No

Press UP / DOWN to select one of the available listed configuration files, and
choose <Yes> to start importing.

NOTE: If the imported configuration has a different record mode from
the unit’s, the warning message “This config has different record mode.

This will FORMAT ALL HARDDISKS.” will show.

NOTE: Remove the ThumbDrive

used for importing

configuration after the unit restarts, or it will be formatted as well.

5.8.3

Export Configuration

The account with appropriate privilege can save a unit configuration by
exporting it to an external drive, such as a USB Flash Drive. Before exporting
the configuration, make sure the device in which the configuration will be
saved is attached to the unit properly. Select <Export Config> from the
Configuration menu and press ENTER. The following menu is displayed.
Items in this menu are described in the following sections.

Export Config

Copy Destination
Config Name
Begin Export