KVH Industries TracVision L2 User Manual

5.  Remove the PCB cover. To get the necessary

clearance, rotate the linear actuator up 90º while
lifting the PCB cover –

6. Remove the screw and clamp holding the cable to

the rotating plate; save the cable clamp for reuse –

7. Remove the Molex connector from J11 on the CPU

board – 

8. Remove the 4 locking nuts and flat washers and

take the antenna gyro off the bracket.

9. Remove the antenna gyro gasket.

10. Replacement is the reverse of this procedure.

1. Connect a PC to the communications port as

2. Type 

ENTER key) while the system is performing the
limit switch initialization routine. The system will
complete the initialization function by finding the
azimuth and elevation switch limits and then go to
the home position.

3. Type 

to enter Debug Mode.

4. Type 

.

5. Type 

. Verify that the Antenna Gyro

Azimuth scale factor is between -0.00090 and 
-0.00110.

6. Type 

. Verify that the Antenna Gyro

Elevation scale factor is between 0.00090 and
0.00110.

7. Type 

to restart/reinitialize the system.