Siemens 300E User Manual
17
Putting into service
Logging mobile units onto a telephone system
Before you can telephone with the mobile unit, you must first open a "logon
window" at Hicom 300 and log on the mobile unit. This is only necessary the
first time the unit is put into service!
window" at Hicom 300 and log on the mobile unit. This is only necessary the
first time the unit is put into service!
l
Ask your Hicom 300 system administrator for the following information:
– code no. (PIN E1) of the Hicom 300 system,
e.g. "
∗∗∗∗∗
82", and check if code no. applies network-wide
– code no. (PIN E1) of the mobile unit (e.g. 6-digit)
– mobile unit call number
– system code of the mobile unit (8-digit)
l
Open the Hicom 300 logon window – at a mobile unit that is already
logged on or at a Hicom telephone with display (at the same network
node):
logged on or at a Hicom telephone with display (at the same network
node):
Code no.
Enter the code no. (PIN E1) at Hicom telephone, e.g.
"
"
∗∗∗∗∗
82".
e.g.
∗∗∗∗∗
82
Enter the number of the Hicom telephone also if the
code no. applies network-wide.
code no. applies network-wide.
Enter code no.
e.g.
123
Enter the code no. (PIN E1) of the mobile unit, e.g.
"123456" – "*" are displayed instead of digits.
"123456" – "*" are displayed instead of digits.
e.g.
Id 34567
e.g.
345
...
Enter the mobile unit call number displayed for
confirmation purposes, e.g. "34567" – the ring tone is
briefly audible. When the ring tone ceases, the Hicom
logon window is "open" for 10 minutes.
confirmation purposes, e.g. "34567" – the ring tone is
briefly audible. When the ring tone ceases, the Hicom
logon window is "open" for 10 minutes.
Note:
The logon window is automatically closed if the mobile unit logon procedure
is not performed within 10 minutes as described below. If this happens you
must repeat the operation.
The logon window is automatically closed if the mobile unit logon procedure
is not performed within 10 minutes as described below. If this happens you
must repeat the operation.