Panasonic KX-TPA50 User Manual

Page of 10
10
Industry Canada Notices and other information
NOTICE:
This equipment meets the applicable 
Industry Canada Terminal Equipment 
Technical Specifications. This is 
confirmed by the registration number. 
The abbreviation, “IC:”, before the 
registration number signifies that 
registration was performed based on 
a Declaration of Conformity indicating 
that Industry Canada technical 
specifications were met. It does not 
imply that Industry Canada approved 
the equipment.
Users should ensure, for their own 
protection, that the electrical ground 
connections of the power utility, 
telephone lines and internal metallic 
water pipe system, if present, are 
connected together. This precaution 
may be particularly important in rural 
areas.
NOTICE:
Operation is subject to the following 
two conditions: (1) this device may 
not cause interference, and (2) this 
device must accept any interference, 
including interference that may cause 
undesired operation of the device.
Privacy of communications may not 
be ensured when using this 
telephone.
Some cordless telephones operate at 
frequencies that may cause 
interference to nearby TVs and 
VCRs. To minimize or prevent such 
interference, the base of the cordless 
telephone should not be placed near, 
or on top of, a TV or VCR. If  
interference is experienced, move 
the cordless telephone further away 
from the TV or VCR. This will often 
reduce, or eliminate, interference. 
RF Exposure Warning:
L
This product complies with IC 
radiation exposure limits set forth 
for an uncontrolled environment.
L
To comply with IC RF exposure 
requirements, the base unit must 
be installed and operated 20 cm  
(8 inches) or more between 
product and all person’s body 
(excluding extremities of hands, 
wrist and feet).
L
This product may not be collocated 
or operated in conjunction with any 
other antenna or transmitter.
L
For body-worn operation, the 
handset must be used only with a 
non-metallic accessory. Use of 
other accessories may not ensure 
compliance with IC RF exposure 
requirements.