Sony SRS A05S Leaflet

Page of 1
Before operating the unit, please
read this manual thoroughly and
retain it for future reference.
WARNING
To prevent fire or shock hazard, do
not expose the unit to rain or
moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
Features
The Sony SRS-A5/A05S is a
compact-size speaker system with a
built-in power amplifier.  This
system can be connected to a CD
player.
• Power output of 80 mW + 80 mW
Precautions
• Operate the system only on 3 V
DC.
• If the system is not to be used for
a long period of time, remove the
batteries to avoid damage caused
by battery leakage and corrosion.
• Do not open the cabinet.  Refer
servicing to qualified personnel
only.
• Do not leave the system in a
location near heat sources, or in a
place subject to direct sunlight,
excessive dust, moisture, rain or
mechanical shock.
• Should any solid object or liquid
fall into the system, remove the
batteries and have the system
checked by qualified personnel
before operating it any further.
• Do not use alcohol, benzine, or
thinner to clean the cabinet.
•Do not leave recorded tapes,
watches, personal credit cards or
floppy disks using magnetic
coding in front of the system for
an extended period of time.
If you have any questions or problems
concerning your system that are not
covered in this manual, please consult
your nearest Sony dealer.
Battery installation
(See fig. A)
Battery Replacement
When the batteries are weak, the
POWER indicator will start
flickering and become faint, or the
playback sound will be distorted or
unstable.  In such a case, replace all
the batteries with new ones.  For
battery life, see “Specifications”.
Connections 
(See fig. B)
How to Use 
(See fig. C)
1
Set the POWER switch to
ON.
The POWER indicator lights
up.
2
Adjust the volume with
the connected equipent.
Turn off the SOUND (CD player)
function as it may cause sound
distortion.
After listening, set the POWER
switch to OFF.
The POWER indicator goes off.
To Carry the System
(See fig. D)
Specifications
Amplifier section
Power output
80 mW + 80 mW
Input cord
Left:  Stereo mini plug (1.0 m)
Input impedance
150 ohms (at 1 kHz)
Speaker section
System
Full-range, open back
Speaker unit
Full-range: ø 57 mm (2 
1
/
4
 in.)
Nominal impedance
3.2 ohms
Rated input power
0.2 W
General
Power requirement
DC 3 V, two R6 (size AA) batteries
(left speaker only)
Battery life (at 5 mW + 5 mW
output)
Approx. 20 hours with Sony
batteries R6,
Approx. 40 hours with Sony
alkaline batteries LR6
Dimensions
Approx. 78 
×
 88 
×
 64 mm
(3 
1
/
8
 
×
 3 
1
/
2
 
×
 2 
5
/
8
 in.) (w/h/d)
Mass
Speaker system: Approx. 240 g
(8.5 oz) not incl. batteries
Design and specifications are subject
to change without notice.
English
CD player
Reproductor de CD
3-860-270-52 (1)
Operating Instructions
Manual de instrucciones
Sony Corporation © 2002  Printed in China
SRS-A5
SRS-A05S
Active Speaker System
A
1
2
Note
Remove the batteries as illustrated.
Nota
Extraiga las pilas como se muestra en
la ilustración.
B
C
Right speaker (rear)
Altavoz derecho
(parte posterior)
Left speaker (rear)
Altavoz izquierdo
(parte posterior)
to a headphones jack
(stereo mini jack)
a la toma para auriculares
(minitoma estéreo)
Left speaker (Rear)
Altavoz izquierdo
(parte posterior)
Two R6 (size AA) batteries
(left speaker only)
Dos pilas R6 (tamaño AA)
(Altavoz izquierdo)
POWER indicator
Indicador POWER
Left speaker (front)
Altavoz izquierdo (parte frontal)
D
Wind the speaker cords.
Bobine los cables de los altavoces
1
Español
Antes de utilizar la unidad, lea este
manual detenidamente y consérvelo
para futuras referencias.
ADVERTENCIA
Para evitar incendios o el riesgo de
electrocución, no exponga la unidad
a la lluvia ni a la humedad.
Para evitar descargas eléctricas, no
abra la unidad. En caso de avería,
solicite los servicios de personal
cualificado.
Particularidades
El SRS-A5/A05S es un sistema de
altavoces compacto, tamaño
bolsillo, con un amplificador de
potencia incorporado.  El sistema
podrá conectarse a un reproductor
de CD.
• Salida de potencia de 80 mW +
80 mW
Precauciones
• Alimente el sistema con 3 V CC
solamente.
• Cuando no vaya a utilizar el
sistema durante mucho tiempo,
extráigale las pilas para evitar el
daño que podría causar el
electrólito de las mismas.
• No abra las cajas acústicas. En
caso de avería solicite los servicios
de personal cualificado.
• No deje el sistema cerca de
fuentes térmicas, ni en lugares
sometidos a la luz directa, polvo
excesivo, humedad, lluvia, o
choques.
• Si dentro del sistema cae algún
objeto sólido o líquido, extráigale
las pilas y haga que sea revisado
por personal cualificado.
• No emplee alcohol, bencina, ni
diluidor de pintura para limpiar
las cajas acústicas.
• No deje sus cintas grabadas,
relojes, tarjetas de crédito o discos
floppy con cintas o codificación
magnética, delante del sistema
durante largos períodos de
tiempo.
Si tiene alguna pregunta o problema
en relación con su sistema que no
pueda resover este manual, póngase
en contacto con su proveedor Sony.
Reemplazo de las
pilas 
(Consulte fig. A.)
Reemplazo de las pilas
Cuando las pilas se debiliten, el
indicador POWER comenzará a
parpadear y se iluminará
débilmente, o el sonido de
reproducción se volverá
distorsionado o inestable. En este
caso, reemplace todas las pilas por
otras nuevas.
Con respecto a la duración de las
pilas, consulte  “Especificaciones”.
Conexión
(Consulte fig. B. )
Forma de empleo
(Consulte fig. C. )
1
Ponga el selector POWER
en ON.
El indicador de alimentación
(POWER) se encenderá.
2
Ajuste el volumen con el
control de volumen del
equipo conectado.
Desactive la función SOUND
(reproductor de CD) ya que podría
causar la distorsión del sonido.
Después de la escucha, ponga el
selector POWER en OFF.
El indicador de alimentación
(POWER) se apagará.
Para transportar el
sistema
(Consulte fig. D. )
Especificaciones
Sección del amplificador
Salida de potencia
80 mW + 80 mW
Cable de entrada
Izquierdo: miniclavija estéreo
(1,0 m)
Impedancia de entrada
150 ohmios (a 1 kHz)
Sección de los altavoces
Sistema
Abierto por detrás, de gama
completa
Unidad de altavoz
Gama completa: ø 57 mm
Impedancia nominal
3,2 ohmios
Potencia nominal de entrada
0,2 W
Generales
Alimentación
3 V CC, dos pilas R6 (tamaño AA)
(altavoz izquierdo solamente)
Duración de las pilas (a una
salida de 5 mW + 5 mW)
Aprox. 20 horas con pilas R6 Sony
Aprox. 40 horas con pilas alcalinas
LR6 Sony
Dimensiones
Aprox. 78 
×
 88 
×
 64 mm
(an/al/prf)
Masa
Sistema de altavoces: Aprox. 240 g
excl. las pilas
Diseño y especificaciones sujetos a
cambio sin previo aviso.