Sony KLV-40S200A User Manual

 GB

KLV-46S200A

2-891-357-11(1)

Press 1 on the TV (top side) to switch on 
the TV.

When the TV is in standby mode (the 1 (standby) 
indicator on the TV (front) is red), press "/1 on 
the remote to switch on the TV.

Press the number buttons or PROG +/- to 
select a TV channel.

To select channel numbers 10 and above using the 
number buttons, enter the second digit within two 
seconds (available only if “1 Digit Direct” is set to 
“Off”).

Even if you press the 1 on the TV (top side) to turn it off, a 
small amount of current continues to flow. Pull the AC plug 
out of the wall jack to turn the TV off completely.

Press /. Each time you press /, the display changes 
cyclically as follows:
Text 

t Text over the TV picture (mix mode) t No 

Text (exit the Text service)
To select a page, press the number buttons or PROG 
+/-.
To hold a page, press 

 

.

To reveal hidden information, press 

 

.

• Ensure that the TV is receiving a good signal, or some text 

errors may occur.

• Some TV channels broadcast a Text service. For 

information on the use of the service, select the index page 
(usually Text page 100).

• When four colored items appear at the bottom of the Text 

page, Fastext is available. Fastext allows you to access 
pages quickly and easily. Press the corresponding colored 
button to access the page.

Turn off the TV 
temporarily 
(Standby mode)

Press "/1.

Turn on the TV 
from Standby mode 
without sound

Press %. Press 2 +/- to set the 
volume level.

Turn off the TV 
completely

Press 1 on the TV (top side).

Adjust the volume

Press 2 + (increase)/
- (decrease).

Mute the sound

Press %. Press again to restore.

Return to the 
previous channel 
watched (for more 
than five seconds)

Press .

Access the Program 
index table

Press MENU, select Program 
List by pressing 

F

/

f

, then press 

. Next, select the desired 

channel by pressing 

F

/

f

, then 

press .

010COV.book  Page 14  Friday, September 8, 2006  9:24 AM