LOEWE 32959022 User Manual

- 10

Install  as  manually  rotatable  table  unit  with  the  Screen  Table  Stand
included.
See Accessories (page 58) for other installation possibilities.

Slowly and carefully remove the protective foil on the trim.

Press the embossed arrow and push down the battery
compartment cover.

Insert  two  alkaline  manganese  LR  0  (AAA)  batteries;
ensure that the + and – poles are correctly positioned!

Slide the cover up from below.

Press the TV button.

See  page  5  to  learn  about  operating  other  Loewe
devices.

Remove the cover for the connections.
Connect the TV set to a 0-40V outlet:

First plug the small plug of the mains cable into the
mains connection on the rear of the TV, then plug the
large plug into a mains power outlet.

Analogue / DVB-C / DVB-T antenna:

Plug the antenna plug of antenna system, cable system,
or room antenna into the ANT2 socket.
The connecting cable between ANT-TV – ANT OUT is
plugged at the factory.

Satellite antenna, if retrofitted

:

Connect an antenna plug, e.g. from the antenna change-
over switch or from the twin-LNC of the satellite system
to the sockets ANT-SAT and ANT-SAT2.
When connecting only one SAT antenna cable, connect
it to ANT-SAT.

Replace the cover over the connections.

When using a CA module and a Smart-Card to receive
coded stations, please observe the handling of the CA
module (see page 4).

Connections on the back of the set (see also page 5).

TV

R

ANT

SAT

ANT

ANT

SAT

0-40V~

50/60Hz