Toshiba 29CZ6TES User Manual
14
Notes
• When “SKIP” is set to “ON” for the selected
position number, a “ * ” mark appears to the
left of the position number.
left of the position number.
12
The position number will then be skipped
when you select the position with CH s/t.
when you select the position with CH s/t.
• If you want to restore a skipped position
number, select it using the -/-- and 0~9 buttons
then switch the “SKIP” setting to “OFF”.
then switch the “SKIP” setting to “OFF”.
Manual fine tuning (MFT)
The adjustments below are not necessary
under normal conditions. However, under
some reception conditions, fine tuning may
be necessary to improve the picture quality.
In such cases, adjust the manual fine tuning
(MFT).
under normal conditions. However, under
some reception conditions, fine tuning may
be necessary to improve the picture quality.
In such cases, adjust the manual fine tuning
(MFT).
1
Select the position number where the
channel you want to fine-tune with CH s/t
or digit selection and number buttons
(-/--, 0~9).
channel you want to fine-tune with CH s/t
or digit selection and number buttons
(-/--, 0~9).
2
Press MENU and then ; -/+ to highlight
the “
the “
TUNING” icon.
3
Press CH s/t to select “MFT”. Press ; -/+
to start fine tuning. Press ; -/+ repeatedly
until the best possible picture and sound
are obtained.
to start fine tuning. Press ; -/+ repeatedly
until the best possible picture and sound
are obtained.
TUNING
MFT
AFT
ASM
MFT
AFT
ASM
SEARCH
POSITION
POSITION
MEMORY
P002
ON
MENU
SELECT / ADJUST –/+ BACK
Auto fine tuning (AFT)
If the signal frequency is unstable due to
environmental conditions, use auto fine tuning.
environmental conditions, use auto fine tuning.
1
Select the position number where the
channel you want to fine-tune with CH s/t
or the digit selection and number (-/--, 0~9)
buttons.
channel you want to fine-tune with CH s/t
or the digit selection and number (-/--, 0~9)
buttons.
Note
When the position is set to “AFT OFF”
status, the “ R ” mark appears to the left of
the position number.
status, the “ R ” mark appears to the left of
the position number.
25
When the channel is set to “AFT ON”
status, the position number is displayed
without the “R” mark.
status, the position number is displayed
without the “R” mark.
2
Press MENU then ; -/+ to highlight the
“
“
TUNING” icon.
3
Press CH s/t to select “AFT”. Press ; -/+
to select the “ON” indication.
to select the “ON” indication.
TUNING
MFT
AFT
ASM
MFT
AFT
ASM
SEARCH
POSITION
POSITION
MEMORY
P002
OFF
MENU
SELECT / ADJUST –/+ BACK
Notes
• When you operate MFT, AFT is switched “OFF”
automatically. If you switch on AFT after fine
tuning with MFT, MFT may be canceled.
tuning with MFT, MFT may be canceled.
• AFT may be set independently for each
position.
CHANNEL PRESET (continued)
EN-01-20[29CZ5DE/29CZ6DA/TES]-1
23/9/05, 9:28 AM
14