TANDBERG 1000 MXP User Manual

TANDBERG 1000 MXP 

4 

 

 

 
 
 
 
 

 

Camera 
 
The camera is an integrated part of the unit 
and is centrally placed just above the 
monitor. 
 
Monitor 
 
The Digital LCD displays the far-end and 
near-end videoconferencing sites in 
addition to the menu. 
 
Codec 
 
The codec is the heart of the system. Its 
main task is the compression of outgoing 
video, audio and data, the transmission of 
this information to the far end and the 
decompression of the incoming information 
- the name codec comes from a 
combination of the two words compression 
and decompression. 
 
 

 
Microphone 
 
The microphone is integrated and located at the edge on the left hand side of the unit.  
 
Headset / push-button 
 
For privacy, a headset may be connected to the connector (audio in and out) located at the edge 
on the left hand side of the unit. The push-button on the front panel will toggle between internal 
microphone/loudspeaker and the headset. 
 
Remote Control 
 
The remote control is used to control all functions of the system. If the screen saver is activated 
(black monitor), touching the remote control will automatically wake up the system. The remote 
control uses 4 AAA batteries. The system will tell you when batteries are running low. Change the 
batteries at the back of the remote control. 
 
The reach of the remote control signal is 20 meters. For users sitting in an open plan office, this 
can cause problems. Use the little, white switch placed under the batteries to change the reach of 
the signal from 20 meters to 2 meters. This will prevent you from unintentionally controlling 
another video system, when you control your own system.