Uniden TL32WRA-B User Manual

Page of 52
 Preparing and Using the Remote Control
How to insert the batteries
•  When operating the remote control, point its top edge at the 
remote control IR receiver on the TV. Operate the remote control 
within seven  meters, 30° on the left and right and 15° above and 
below the receiver.
•  If the TV cannot be operated by remote control operation (but by 
  the buttons on the TV), a probable cause is that the batteries in 
the remote control have reached the end of their service life. 
• Replace with new batteries.
•  Do not leave or attach the remote control in a location subject to direct sunlight.
•  Heat may deform the remote control and cause it to malfunction.
•  The remote control becomes more difficult to operate if direct sunlight or bright overhead lighting falls 
on the remote control IR receiver on the TV.  Either re-orient the lighting or TV, or bring the remote 
control closer to the remote control IR receiver.
•  Do not subject the remote control to strong impact.  Also, do not allow it to get wet or leave it in very 
hot locations. 
Close the battery compartment cover.
Rest the cover along the back with the clip 
aligned and push/slide the cover until you 
hear it click into place.
Insert the batteries.
Insert two AAA batteries by matching the + 
and - terminals on the batteries to the dia-
gram inside the battery compartment.
(Make sure that the poles are facing the cor-
rect direction.) 
Open the battery compartment cover.
Remove the cover by pushing down where 
the cover edge is marked and slide the cover 
backwards.
How to use the remote control
Left/right 30°
Up/down 15°
Remote Control signal range
7 metres
SET
 UP
15
1
2
3