TANDBERG 6000MXP User Manual

Page of 296
Installation 
23 
 
2.2  Connecting Cables 
 
 
All cables needed in standard configuration are already connected to the codec. Connect these 
cables to their respective parts of the system. 
 
1. Power cables 
Connect the power cable to an electrical distribution socket. 
 
2. Monitor cables 
Connect the DVI cable to the input on your monitor. 
 
3. Microphone cables 
Connect the microphone cable to the microphones. 
 
4. Camera cable 
Connect the camera cable labeled 
Main Cam
 to the S-Video connector on the camera. Connect 
also the control cable labeled 
Camera Control
 between the RJ-45 on the camera, and the 
Dataport 2 on the codec. 
 
5. PC cable 
Connect the PC cable to the PC. 
 
6a. ISDN cables - using BRI interface 
Connect the ISDN cables to the ISDN sockets (S/T interface) provided by the network provider. 
The main ISDN number will be that number associated with the socket to which ISDN cable 
number 1 has been connected. 
 
 
Note! The system does not have a built-in network terminator. If wall socket provides an 
ISDN U-interface, an NT1 between your system and the ISDN line is needed, see 
 for more information.  
 
 
6b. ISDN cable - using the PRI interface  
If using the PRI interface, the E1/T1 cable should be connected to a CSU (Channel Service Unit). 
). It is recommended that a CSU be used between the system and the PRI line from the network 
provider, see 
 
6c. Other networks - using the External Network interface 
If using other networks, see 
 and 
 
 
7. LAN cable 
To connect the system to a Local Area Network (LAN), connect the cable labelled "LAN Ethernet" 
to a suitable Ethernet port on the LAN.