Venturer PLV76198E User Manual

GB - 5

When you turn on your television set for the first time, be sure to place it on a solid stable surface. To avoid danger, do

not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the ventilation grid at the rear

and be sure to leave sufficient gaps around the unit as shown.

1. Connect  an  antenna  or  Cable  TV  COAX  cable  to  the  TV's

antenna input jack.

2. Connect the power cord.

3. Press the   / ON button to turn on the unit.

4. Use the   /   button to highlight

OSD Language, then press

the  ENTER  or    button  to  select  the  menu  language  from

English / Español / Français.

5. Press  the    /    button  to  highlight  Antenna,  then  use  the

ENTER or   button to select “Air”, “Cable STD”, “Cable HRC”,

“Cable IRC” or “Cable Auto“.

6. Use the   /   button to highlight Auto Scan, then press the

ENTER or   button to confirm.

7. The  unit  will  immediately  search  all  channels  for  those  with

adequate signal strength and store those channels with signals

in memory. The unit will take a few minutes to finish auto scan

and  after  this  is  completed,  the  unit  will  switch  to  the  first

channel found.

The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt message on the

screen to complete basic TV settings.

Make sure the TV antenna or CATV cable has been connected properly to the TV antenna input jack on the rear of

the system.

If you subscribe to Cable TV Service, we recommend you pick

"Cable Auto", however you might find you get improved results

using "Cable STD", "Cable IRC", or "Cable HRC" - these are

different standards used by various Cable Systems.

2 3/8”

2 3/8”

7 7/8”

PLV76198S23E10 IB ENG.indd   5

9/8/2009   9:57:24 AM