Metz 20 TK 51 User Manual

- 40 -

Before Switching on your TV

Power connection

$ &DGDSWHU

7R32:(5

,1387'&9

WHUPLQDO

IMPORTANT: The TV set is designed to op-

erate  on  12  V  DC.  For  this,  an  adaptor  is

used which gives 12V DC voltage. Connect

this  adaptor  to  a  system  that  supplies

230V AC, 50 Hz.
• After unpacking, allow the TV set to reach the

ambient room temperature before you con-

nect the set to the mains.

Connections to the RF input

socket

VHF /UHF

W

795($53$1(/

&$%/(79

• Connect the aerial or cable TV plug to the

RF input socket located at the back of the TV

and connect the cable plug coming out from

the TV out socket located at the devices

(VCR, DVB etc.) to this socket as well.

How to connect other devices

IMPORTANT: Switch off the TV before con-

necting any external device.
Sockets  for  external  connections  are  at  the

back  of  the  TV.  For  connection  of  other  de-

vices via Euroconnector refer to the manuals

of the related devices.

Inserting batteries in the remote

control handset

• Remove the battery cover located on the

back of the handset by gently pulling up-

wards from the indicated part.

• Insert two AAA (R03) or equivalent type of

batteries inside.

• Replace the battery cover.

Switching the TV ON/OFF

To switch the TV on

Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-

tem. Then set the power switch to the "1"

position. After this process, the TV

switches itself to stand-by mode and the

led becomes red located on the front of

the TV.

2- To switch on the TV from stand-by mode

either:

Press the “ ” button at the top of the TV,
or,
Press a digit button on the remote control so

that  a  programme  number  is  selected,
or,
Press “P/Ch” button at the top of the TV or

press  “P-”  or  “P+”  buttons  on  the  remote

control,  so  that  last  switched  off  programme

is  selected.