Bosch UML-262-90 User Manual

en | Safety

Full HD LCD Monitors

F.01U.172.600 | 1.0 | 2010.10

User’s Manual

Bosch Security Systems, Inc.

NOTE: Wear required grounded wrist straps and observe proper 

ESD safety precautions when handling the electrostatic-

sensitive printed circuit boards.

Fuse rating - For security protection of the device, the branch 

circuit protection must be secured with a maximum fuse rating 

of 16A. This must be in accordance with NEC800 (CEC Section 

60).

Grounding and polarization - This unit may be equipped with a 

polarized alternating current line plug (a plug with one blade 

wider than the other blade). This safety feature allows the plug 

to fit into the power outlet in only one way. If unable to insert 

the plug fully into the outlet, contact a locally certified 

electrician to replace the obsolete outlet. Do not defeat the 

safety purpose of the polarized plug.

Alternately, this unit may be equipped with a 3-pole grounding 

plug (a plug with a third pin for earth grounding). This safety 

feature allows the plug to fit into a grounded power outlet only. 

If unable to insert the plug into the outlet, contact a locally 

certified electrician to replace the obsolete outlet. Do not 

defeat the safety purpose of the grounding plug.

Moving - Disconnect the power before moving the unit. Move 

the unit with care. Excessive force or shock may damage the 

unit and the hard disk drives.

Outdoor signals - The installation for outdoor signals, especially 

regarding clearance from power and lightning conductors and 

transient protection, must be in accordance with NEC725 and 

NEC800 (CEC Rule 16-224 and CEC Section 60).

Permanently connected equipment - Incorporate a readily 

accessible disconnect device in the building installation wiring.

Pluggable equipment - Install the socket outlet near the 

equipment so it is easily accessible.

Power resupply - If the unit is forced to power down due to 

exceeding the specified operating temperatures, disconnect 

the power cord, wait for at least 30 seconds, and then 

reconnect the power cord.