Aiphone IE-SSV User Manual
- INSTRUCTIONS -
The IE-SSV is a 2-gang stainless steel vandal proof and weather resistant sub station designed for use with the
systems listed above. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. The
unit either flush mounts into a 2-gang box, or surface mounts using the SBX-2G. Each unit includes a 12V DC power
supply for the camera, tamper proof screws, and a tool for installation.
systems listed above. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. The
unit either flush mounts into a 2-gang box, or surface mounts using the SBX-2G. Each unit includes a 12V DC power
supply for the camera, tamper proof screws, and a tool for installation.
Vandal Resistant Sub Station with built in Color Pinhole Camera
for use with AX, IE, TC-M, or TD-H Systems
Page 1
Transparent corner shadowing
on the picture is normal.
on the picture is normal.
Front View
Back View
The view achieved if the subject is 20" from the
camera is: 18" Vertically and 26½” Horizontally
camera is: 18" Vertically and 26½” Horizontally
Speaker
Camera
Red Lit
Call button
Call button
45cm
18”
67cm
26½”
50cm / 20”
50cm
20”
INSTALLATION:
1. For flush mounting, install sub station in standard 2-gang electrical box with minimum 2-1/2" depth.
2. For surface mounting, use the SBX-2G surface mount enclosure (sold separately).
3. Only the 12V DC power supply included should be used to power the IE-SSV camera.
4. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and
evaporation of moisture that naturally gets into the unit.
2. For surface mounting, use the SBX-2G surface mount enclosure (sold separately).
3. Only the 12V DC power supply included should be used to power the IE-SSV camera.
4. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and
evaporation of moisture that naturally gets into the unit.
Do not apply caulking or silicone sealant around the
unit when installing, and do not use weather stripping around the perimeter of the box when mounting
. If
sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from
dissipating from inside the unit, which may cause corrosion or deterioration of the internal components over time.
dissipating from inside the unit, which may cause corrosion or deterioration of the internal components over time.
Microphone
0607