Panasonic VL-SW250BX User Manual
45
Expanding the System
Setting a repeater (REGISTRATION)
You can set up to 2 optional repeaters (page 4).
L
One repeater can relay radio waves between
the main monitor station and multiple sub
monitor stations.
the main monitor station and multiple sub
monitor stations.
L
If you set a repeater between the main monitor
station and sub monitor stations located at a
distance, the repeater expands the radio wave
range and may improve image distortion and/or
sound cutting in and out.
station and sub monitor stations located at a
distance, the repeater expands the radio wave
range and may improve image distortion and/or
sound cutting in and out.
Perform the following operations to register the repeater to the main monitor station, then install the repeater
according to the Operating Instructions included with the repeater.
according to the Operating Instructions included with the repeater.
Registering the repeater to the main monitor station (REGISTRATION)
Place the repeater near the main monitor station and then operate the repeater within 2 minutes in succession to
the operations of the main monitor station.
the operations of the main monitor station.
Using the main monitor station
XX
{
OFF}
{
PAGE}
{
MENU}
{
VOLUME}
1
Press {MENU}, then select “REGISTRATION/
CANCELLATION” by pressing {VOLUME} (
CANCELLATION” by pressing {VOLUME} (
▲
) or
{
PAGE} (▲).
FUNCTION SETTINGS
TIME AND DATE SETTINGS
RING TONE SETTINGS
CONNECTED DEVICE SETTINGS
REGISTRATION/CANCELLATION
2
Press {MENU} (OK), then select “REGISTRATION”
by pressing {VOLUME} (
by pressing {VOLUME} (
▲
) or {PAGE} (▲).
3
Press {MENU} (OK), then select “REPEATER” by
pressing {VOLUME} (
pressing {VOLUME} (
▲
) or {PAGE} (▲).
4
Press {MENU} (OK), then select the repeater to be
registered by pressing {VOLUME} (
registered by pressing {VOLUME} (
▲
) or
{
PAGE} (▲).
5
Press {MENU} (OK).
Operate with the repeater within 2 minutes.
VL-F
AN1
STATUS
IN USE (LED)
PROGRAM
PROGRAM
{
PROGRAM}
STATUS indicator
To power outlet
(100 – 240 V AC)
(100 – 240 V AC)
6
While the power is on, press and hold
{
PROGRAM} for about 3 seconds.
L
The STATUS indicator fl ashes in green.
L
After completing the registration, the indicator
lights up solid.
lights up solid.
7
To end the operation, press {OFF} on the main
monitor station.
monitor station.
Important:
L
L
If you register two repeaters, please separate them
more than 3 meters to avoid electrical noise.
more than 3 meters to avoid electrical noise.
Using the repeater
SW250BX_OI.indb 45
SW250BX_OI.indb 45
2010/08/25 15:58:38
2010/08/25 15:58:38