Epson DH200 User Manual

83

Appendix H: Replacing the Hard Drive

To replace the hard disk:

1. Carefully position the new hard drive on the four rubber mounting feet in the housing. The 

connections end of the hard drive should face the data and power cables.

2. With your hand supporting the hard drive, replace the four mounting screws underneath the 

housing.

3. Reconnect the cables to the hard disk. Make 

sure the cables are connected firmly.

4. Carefully replace the cover over the housing 

and slide towards the front panel. The cover 
should be flush on all sides.

5. Replace the screws on the rear panel: 3 short 

screws at the corners, 1 longer screws at the 
top, and 4 longer screws along the video ports.

6. Replace the short screws on the side panels.
7. Reconnect all cameras and cables. Re-mount 

the unit the back of your monitor if desired.

8. Power on the system. If you have installed a 

new hard disk, you must format the hard disk 
before using the system.

Figure 44.2 Place the HDD on the rubber mounting feet

Figure 44.3 Reconnect the power and data cables