Fostex D2424 User Manual

114

 Model D2424  Reference Manual (Changing the Initial Settings <SETUP mode>)

Flashing

Flashing

Setting an MTC frame rate

1.While the recorder is stopped, press the [SETUP]

key to enter SETUP mode.

2.Turn the [JOG] dial to select “Frame Rate ?” ( “?”

flashes), then press the [EXECUTE/YES] key.

The current frame rate setting appears on the display.
Press the [

EXECUTE/YES

] key to turn off the flashing “

?

”

character; the current setting flashes.
The initial setting of “

25

” flashes as shown below.

3.Turn the [JOG] dial to enter the desired frame rate.

Rotating the [

JOG

] dial clockwise or counter-clockwise

displays available frame rates as an alternative.

4.Press the [EXECUTE/YES] key.

The selected frame rate is stored and the display returns
to the indication with a flashing “

?

” that appeared in

step 2.

To cancel the operation, or to restore the setting
obtained prior to the [EXECUTE/YES] key press, press
the [STOP] button or the [EXIT/NO] key.  Each time
you press one of these keys, the recorder returns to
the previous hierarchy level of the menu, and finally
exits SETUP mode and displays the previous Time Base.

 <Note>

There are no 29.97nd or 29.97df in the MTC standard.
Use either 30nd or 30df unless you definitely need to
synchronize the recorder with NTSC video.

Setting an MTC offset value (“MTC Offset?” menu)

The “Setting an MTC offset value” menu enables you to specify an offset time value - the difference between
the time of MTC output from the recorder and the ABS 00m 00s 00f 00sf time.  You need to specify this value
if you have selected “

MTC

” for the “

Setting MIDI sync output signal

” menu.

With the initial setting of 00h 59m 57s 00f 00sf, for example, MTC of 59m 57s 00f 00sf is output at the ABS
time 00m 00s 00f 00sf.  You can also set an offset value from the 001bar 1beat  00clk value (bar/beat) on the
Tempo Map.  Refer to the next section for information on MTC Offset mode.

• Initial setting:

[00h: 59m: 57s: 00f: 00sf]

• Setting range of offset time:

00h: 00m: 00s: 00f: 00sf - 23h: 59m: 59s: 29f: 99sf

* You can set the value for each Program individually.
* The settings can be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the recorder.

Setting an MTC offset

1.While the recorder is stopped, press the [SETUP]

key to enter SETUP mode.

2.Turn the [JOG] dial to select “MTC Offset?” (“?”

flashes.), then press the [EXECUTE/YES] key.

The current offset value appears on the display.
Pressing the [

EXECUTE/YES

] key turns off the flashing

“

?

” character, and the value in secondsflashes.

You can enter a value at the flashing digit.
The number “

57

” of the initial setting “

57s

” flashes as

shown below.

∞

∞

∞

∞

∞

∞

∞

∞