GE BusSecure User Manual

Hardware Installation 

BusSecure User Manual 

 

14 

0150-0263A / May 2003 

The Impact Sensor is typically mounted near the DVR and comes with a 7-foot cable that terminates in 
the DVR. 

CAUTION 
Do not install the Impact Sensor until you have tested its functionality on each vehicle. The Impact Sensor 
should be mounted on a flat, stable surface and secured to the frame of the vehicle. The mounting surface 
must not be subject to vibrations. 

1)  Using the Impact Sensor as a template, mark the location of the two mounting holes. The Impact 

Sensor should be aligned so that it is square with the front and rear of the vehicle. See Figure 16. 

2)  Drill the mounting holes with an appropriate size drill bit. 

3)  Mount the Impact Sensor. 

4)  Route the provided cable to the DVR. Connections to the P1 terminal block on the DVR Rear Panel 

Assembly are as follows: N/C wire (green or white) to terminal 1, common wire (black) to terminal 2, 
positive wire (red) to terminal 18. 

 

  Align square with the front and rear of the vehicle

 

  Align square with the sides of the vehicle

 

  Cable to DVR Rear Panel Assembly