JVC DR-M1SLB User Manual
Filename [DR-M1EK_08Recording.fm]
Masterpage:Left+
Page 60
September 4, 2003 11:22 am
TIMER RECORDING (cont.)
60
On-Disc Timer
Programming
On-Disc Timer Programming is a function used with discs that
are especially intended for a specific programme. The disc is
then programmed for a programme you always watch every day
or every week. Since older programs are automatically
overwritten, a single DVD-RAM/RW (VR mode) disc can be used
without worrying about how much recording capacity remains.
(
are especially intended for a specific programme. The disc is
then programmed for a programme you always watch every day
or every week. Since older programs are automatically
overwritten, a single DVD-RAM/RW (VR mode) disc can be used
without worrying about how much recording capacity remains.
(
You can programme each disc to timer-record as many as
8 programmes.
8 programmes.
To make the disc for On-Disc Timer
Programming
Programming
A
Load a disc.
A Press x to open the disc tray.
B Place a recordable disc on the disc tray.
● For details, refer to “Placing a Disc” (
C Press x to close the disc tray.
B
Access Programme Check screen.
Press PROG/CHECK.
C
Access the programme screen.
When On-Disc Timer Programming is made for the first
time on the disc
Press
time on the disc
Press
rt repeatedly to select “DISC TIMER PRGM”,
then press ENTER.
● When some programmes are recorded on the disc, a caution
message appears. In such a case, backup the programmes as
required, then format the disc before making On-Disc Timer
Programming. (
required, then format the disc before making On-Disc Timer
Programming. (
When On-Disc Timer Programming has already been
made on the disc
Press
made on the disc
Press
rt repeatedly to select “NEW TIMER
PROGRAMME”, then press ENTER.
D
Enter the recording date.
Press
rt repeatedly to set the desired date.
● The current date appears on the TV screen. The date you enter
appears in its place.
E
Enter the recording start time.
Press
w e to select “START”, then press rt repeatedly
to set the desired start time.
● Each press of rt advances/goes back the start time in 1-min.
increments.
● To advance/go back the start time in 30-min. increments, press
and hold
rt.
Before performing On-Disc Timer Programming:
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
● Make sure that the unit’s built-in clock is set properly.
ATTENTION:
● On-Disc Timer Programming is possible only with the disc
for On-Disc Timer Programming.
● If data is recorded on a disc for On-Disc Timer
Programming using a unit from another manufacturer, On-
Disc Timer Programming may no longer function properly.
Disc Timer Programming may no longer function properly.
DR-M1EK_08Recording.fm Page 60 Thursday, September 4, 2003 11:23 AM