Motorola DCH6416 User Manual
2 OVERVIEW
7
Rear Panel
The rear panel contains a switched power outlet; connectors for video, audio, and RF
cabling; data output; and modem and data interface connectors. Some connectors
are not enabled and require the support of application software.
cabling; data output; and modem and data interface connectors. Some connectors
are not enabled and require the support of application software.
Figure 2-2 Rear panel
SERIAL
DIGITAL AUDIO
USB
SWITCHED
105 125V
60Hz
4A MAX
500W MAX
105 125V
60Hz
4A MAX
500W MAX
-
IEEE 1394
ETHERNET
M Card DEVICE ONLY
-
™
S VIDEO
-
HDMI
eSATA
Pr
OUT
VIDEO AUDIO
/
IN
R
L
V
Pb
Y
RPT OUT
RF OUT
RF1
IN
CM
IN
RF2
IN
CABLE
IN
Table 2-2 Rear panel connections
1
Cable In—Connects to cable signal from your service provider
2
RF Out—Ch 3/4 modulated audio/video (SDTV) to TV or VCR
3
M-Card—Input slot for CableCARD (M-Card device only). If the M-Card
was pre-installed in the factory there will be a cover attached over the slot.
was pre-installed in the factory there will be a cover attached over the slot.
4 Serial—Service
only
5
S-Video—Connects to S-Video
(SDTV)
input of TV or VCR
6
Digital Audio (S/PDIF)—Provides Dolby
®
Digital 5.1 audio or PCM output
7
YPbPr—Component video output
(HDTV)
8
Video/Audio—Composite Video
(SDTV)
/Audio L/R inputs and outputs
9
HDMI—High-Definition TV
(HDTV)
connector
10
eSATA*—External Serial ATA disk interface
11 Ethernet*—Network
connection
12
USB* 2.0—High-Speed peripheral device connection
13
IEEE-1394—Audio and video device connection
14
Power cord connector
*The availability of certain features is dependent upon application support.