Multiplex Technology 4CH User Manual
23
4.10 ADVANCE MENU ___REMOTE
4.10 ADVANCE MENU ___REMOTE
Move the cursor to “REMOTE”, and press ”ENTER”, then the screen will show the
following options.
following options.
REMOTE
REMOTE
TITLE
DEVICE
ID
PROTOCOL
RATE
01
PTZ
001
P - D
02400
02
CAMERA
002
NORMAL
02400
03
CAMERA
003
NORMAL
02400
04
CAMERA
004
NORMAL
02400
05
CAMERA
005
NORMAL
02400
06
CAMERA
006
NORMAL
02400
07
CAMERA
007
NORMAL
02400
08
CAMERA
008
NORMAL
02400
PREV
NEXT
1)
TITLE:
Title of each camera.
Title of each camera.
2)
DEVICE:
Select to control normal camera or PTZ camera for each channel.
Select to control normal camera or PTZ camera for each channel.
3)
ID:
Set the ID number (0 ~ 255) of PTZ camera.
Set the ID number (0 ~ 255) of PTZ camera.
Note: After connect to PTZ correctly, the default ID of PTZ will be shown on the screen
.
Note: Please refer to below instruction “PTZ Connection and Control”.
4)
PROTOCOL:
Select NORMAL (our protocol) or PELCO-D protocol.
Select NORMAL (our protocol) or PELCO-D protocol.
5)
RATE:
Set the baud rate of each channel (2400, 4800, 9600, 19200, 57600).
Set the baud rate of each channel (2400, 4800, 9600, 19200, 57600).
***PTZ Connection and Control: ***
***PTZ Connection and Control: ***
1)
Device
Device: Our own brand PTZ / Pelco-D protocol PTZ
2)
Connection
Connection: Detailed connection and instructions, please refer to PTZ manual.
Note:
Note:
As for “RS485A and RS485B Port” please refer to
As for “RS485A and RS485B Port” please refer to
“Section 1.5 Rear Panel”, or refer to
“Appendix #2 PIN Configuration”.
3)
Control Mode
Control Mode: Refer to front panel / Refer to IR remote control manual.
Take 16CH as an example
Take 16CH as an example