Pelco DX9000 User Manual

C662M-E (5/03)

81

Figure 98.  CM9760-REL Configuration

Table L.  CM9760-REL Settings

Baud Rate

Set the baud rate according to the External Relay device settings.

Parity

Set the parity according to the External Relay device settings.

COM Port

This is the COM port on the viewstation that the relay unit is connected to.

Frame Address

This should be set with the default values of 0.

Default Latch Time (sec)

The minimum time that is detected by the relay unit. This sets the latch time for all the relay
ports.

Relay

Define the relay port number that you want to change. The first port on the relay unit is 0.

Latch Time (sec)

The minimum time that is detected by the relay unit for the specific port.

Add

Set the new latch time for the specific port.

Remove

Set the default latch time for the specific relay port.

7.

Set the baud rate to 9600 and the parity to Even.

8.

Enter the COM port that the relay unit is connected to on the viewstation.

9.

Click OK.

10. Click Test.