Bosch 430 User Manual

Video Recorder 430/451 Series

 Safety | en

Bosch Security Systems

Installation and Operation manual

F.01U.168.054 | v2.0 | 2012.05

All-pole power switch - Incorporate an all-pole power switch, with a contact separation of at 

least 3 mm in each pole, into the electrical installation of the building.If it is needed to open 

the housing for servicing and/or other activities, use this all-pole switch as the main 

disconnect device for switching off the voltage to the unit.

Battery replacement - For qualified service personnel only - A lithium battery is located 

inside the unit enclosure. To avoid danger of explosion, replace the battery as per 

instructions. Replace only with the same or equivalent type recommended by the 

manufacturer. Refer all servicing to qualified service personnel.

Batteries must not be disposed of in household waste. Dispose of batteries only at suitable 

collection points and, in the case of lithium batteries, mask the poles.

–

Ground the cable system if connecting an outside cable system to the unit.

–

Connect outdoor equipment to the unit's inputs only after this unit has had its grounding 

plug connected to a grounded outlet or its ground terminal is properly connected to a 

ground source.

–

Disconnect the unit's input connectors from outdoor equipment before disconnecting 

the grounding plug or grounding terminal.

–

Follow proper safety precautions such as grounding for any outdoor device connected to 

this unit.

U.S.A. models only - Section 810 of the National Electrical Code, ANSI/NFPA No.70, provides 

information regarding proper grounding of the mount and supporting structure, grounding of 

the coax to a discharge unit, size of grounding conductors, location of discharge unit, 

connection to grounding electrodes, and requirements for the grounding electrode.

Electronic Surveillance - This device is intended for the use in public areas only. U.S. federal 

law strictly prohibits surreptitious recording of oral communications.

Electrostatic-sensitive device - Use proper CMOS/MOS-FET handling precautions to avoid 

electrostatic discharge. Wear required grounded wrist straps and observe proper ESD safety 

precautions when handling the electrostatic-sensitive printed circuit boards.

Accessories - Do not place this unit on an unstable stand, tripod, bracket, or mount. The unit 

may fall, causing serious injury and/or serious damage to the unit. Use only with the cart, 

stand, tripod, bracket, or table specified by the manufacturer. When a cart is used, use 

caution and care when moving the cart/apparatus combination to avoid injury from tip-over. 

Quick stops, excessive force, or uneven surfaces may cause the cart/unit combination to 

overturn. Mount the unit per the manufacturer's instructions.

Invisible laser radiation when open. Avoid exposure to beam.

Disposal - Your Bosch product was developed and manufactured with high-quality material 

and components that can be recycled and reused. This symbol means that electronic and 

electrical appliances, which have reached the end of their working life, must be collected and 

disposed of separately from household waste material. Separate collecting systems are 

usually in place for disused electronic and electrical products. Please dispose of these units 

at an environmentally compatible recycling facility, per European Directive 2002/96/EC.