Clover Electronics LCD22164 User Manual

Stand-alone DVR

Instruction Manual

(screen) as shown

[Fig.5-4-2].

- Attach the mounting bracket to the desired location on the wall. Locate wall studs and

securely fix the mounting bracket with the supplied screws.

5-4.2.1. Connection of Composite Monitor

If necessary, connect the composite Video Output (yellow RCA) and Audio Output (white

RCA) to Video IN and Audio IN on a composite monitor or TV (RCA cable: not included).

5-4.3. Sensor Connection and RELAY IN &OUT

▫ SENSOR Connection (SENSOR IN)

Connect up to 8 sensors to ALM (SENSOR) IN. The Sensors should be contactor type and

support N.O. (Normal Open).

[Fig 5-5 SENSOR IN PIN]

▫

ALARM OUT Connection

When necessary, use ALARM OUT. The ALARM OUTPUT is a relay contactor type and

supports N.O. (Normal Open) and N.C. (Normal Close). The Output capacity is 220V 1A. A

higher capacity can cause system failure.

[Fig 5-5]

Note

- Pay attention to not make scratches or dents on the surface of panel (screen)

during installation of the system.

- In case of this, the warranty will be voided.

RS-485

[Fig 5-6 Alarm Output]