Clover Electronics MVR1020 User Manual
4-2. How to Connect DC power to DVR unit
(
Rear View)
○
A
or ○
B
4-2-1. When Installing the DVR in a Vehicle
Cut out the DC jack on the provided DC power wires as shown in Fig.4-1, and
then connect wires as follows.
GROUND: Connect the BLACK colored wire to vehicle’s chassis (Do not
connect it to the gas tank or the airbag area).
DC 9V TO 40V (HOT): Connect the RED colored wire to the DC power line
that supplies DC 12V or DC 24V when ignition switch is in the “ON” position.
Red
Fuse (250V.3A)
○
A
Black
Fig.4-1 Power Cable
4-2-1. When installing the DVR in a vehicle
CAUTION
Connect the 4 pin connector with 2 wires in polarity to the power in jack on
the rear panel after connecting Ground and Hot (B+) as mentioned above.
- 8 -