Panasonic TZ-DRD100 User Manual
39
R
OLLER
G
UIDE
M
ENU
O
PERATIONS
Setup : Satellite Setup – Dish position
This screen allows you to position your Satellite antenna by having the Digital Satellite
Receiver provide approximate values for elevation, azimuth and tilt (marked in degrees),
after the you have entered your 5-digit zip code.
Receiver provide approximate values for elevation, azimuth and tilt (marked in degrees),
after the you have entered your 5-digit zip code.
Procedure
r
In Sat Setup menu, press
pq
buttons to highlight Dish Position. Dish Position sub menu is
displayed.
r
Press
u
button to enter your Zip code. Use the numeric keys on the Remote Control to input
your zip code numbers. Press
u
button to move to the next position.
r
Press ACTION button to enter the new zip code. Elevation, Azimuth and Tilt are automatically
displayed after you press the ACTION button.
displayed after you press the ACTION button.
r
This information should be used to properly align and position the satellite antenna. These
values are approximations. Proper alignment should also be verified by using the signal strength
meter.
values are approximations. Proper alignment should also be verified by using the signal strength
meter.
Setup : Satellite Setup – Signal Meter
Since the Digital Satellite Receiver is capable of receiving satellite programming from
multiple DIRECTV satellites, the user has the ability to choose one of 3 supported
satellites to receive signal strength and is primarily used during the system set-up
procedure. The Digital Satellite Receiver signal meter uses a horizontal digital signal
strength percent bar meter. The user will have the ability to select which transponder (1 to
32) they wish to measure the signal strength. The following is the signal meter screen
multiple DIRECTV satellites, the user has the ability to choose one of 3 supported
satellites to receive signal strength and is primarily used during the system set-up
procedure. The Digital Satellite Receiver signal meter uses a horizontal digital signal
strength percent bar meter. The user will have the ability to select which transponder (1 to
32) they wish to measure the signal strength. The following is the signal meter screen
.
Procedure
r
In the Sat. Setup menu, press
q
button to highlight Signal Meter. Sub- menu is displayed.
r
Press
u
to highlight Satellite.
r
Press
u
to change Satellite
r
Press
pq
buttons to select Satellite A, B or C.
r
Press ACTION to enter the selection.
r
Press
q
button to highlight Transponder.
r
Press
u
button then
pq
buttons to choose one of 32 transponders. Select the transponder
that gives you a signal strength of 85%.
r
Press
t
two times to return to SETUP menu.
q
Sat Setup
Sat Ports
Dish Pos
Sig Meter
Zip code for position 92154
Elevation
Azimuth
Tilt
51 degrees
166 degrees
101 degrees
Dish position screen
Press
u
to change the zip code.
Enter zip code, press ACTION
Signal Meter Screen
q
Sat Setup
Sat Ports
Dish Pos
Sig Meter
Press
u
to change satellite.
Satellite
Transponder
u
A
1 of 32
Signal strength 91%