TechniSat DIGITY 1 User Manual

>

Switch the receiver on by pressing the 

On/Standby key on the remote control unit.

>

Press the key again to switch the receiver off again.

>

The receiver is now in standby mode.

>

Use the 

programme up/down keys on the remote control unit to move up or

down by one programme slot at a time.

>

Use the 

numeric keys to enter the desired programme number directly.

For example

1

1

1

1, then 4

4

2

2,, then 3

3, then 4

4

When entering multi-digit programme numbers, you have approx. 3 seconds after pressing
each digit to complete the entry.
If you wish to enter a programme number consisting of only one or two digits, you can speed
up the selection process by holding down the key of the last digit for a little longer.

You have the facility to adjust the volume of your receiver. This facilitates use of the receiver,
as it combines all important functions on the receiver remote control unit, so that you will
rarely have to use your TV set remote control unit. When the receiver is switched on, sound
will be reproduced at the volume level last set.
>

Adjust the volume of your receiver by using the 

Volume + key to make it louder, and

the  

Volume - key to reduce volume.

>

Press the 

Sound on/off key to mute the sound, press the key again to switch the

sound back on again.

The receiver has been pre-programmed for both TV and radio programmes. When the latte-
ris selected, the TV image is switched off, and only the programme name is displayed.
>

Use the 

TV/Radio key to switch the receiver into radio mode.

The receiver will now play the last radio programme selected previously.

>

Press the 

TV/Radio key again to display the last TV programme selected previously

38

bed_anl_DIGITY 1_englisch_4.qxd  21.06.02  13:41  Seite 38