EchoStar 9630 User Manual
Page 9
11. Run wires from the back of the dome unit to the roof edge, then along edge to location
where wiring will be fed into the vehicle. (If installing an optional second receiver, run
auxiliary coax to location where it will enter the vehicle.) Secure wiring to roof every
12-18 inches (Fig. 10).
auxiliary coax to location where it will enter the vehicle.) Secure wiring to roof every
12-18 inches (Fig. 10).
12. Drill 3/4” hole through the roof and into the cabinet where receiver is stored. Feed wiring
down through hole. Seal opening with roof compatible sealant so that it is entirely
waterproof (inside and outside of the 3/4” hole). Repeat for optional second receiver
(Fig. 10).
waterproof (inside and outside of the 3/4” hole). Repeat for optional second receiver
(Fig. 10).
13. Remove blue protective sheet and red “position to rear” sticker from the dome unit.
Fig. 10
TYPICAL ROOF INSTALLATION - OVERHEAD VIEW
IMPORTANT!
Sealant must
be roof
compatible.