EchoStar 44 User Manual
7
Installation Instructions
The following instructions assume you have already installed
and pointed your dish(es) for the strongest possible signal,
have run Check Switch, and have allowed the receiver to
take a software upgrade. If not, you must complete the dish
installation using the instructions which came with the dish
and receiver before starting this switch installation.
and pointed your dish(es) for the strongest possible signal,
have run Check Switch, and have allowed the receiver to
take a software upgrade. If not, you must complete the dish
installation using the instructions which came with the dish
and receiver before starting this switch installation.
Note: For DISH Pro Plus-compatible receivers, you can
complete these installation instructions with only one
S
complete these installation instructions with only one
S
ATELLITE
I
N
connected.
Note: Legacy receivers may be directly connected to a DISH
Pro LNBF to peak the satellite dish and take the software
download using odd transponders (for example, transponder
11).
Pro LNBF to peak the satellite dish and take the software
download using odd transponders (for example, transponder
11).
Mounting and Connecting the Switch
Refer to the wiring diagrams starting on page 17 and
complete the instructions below to mount and connect the
switch to your system:
complete the instructions below to mount and connect the
switch to your system:
1. Mount the DISH Pro Plus 44 switch onto the side of a
building, or on some other sturdy structure. Make sure
that the mounting location is stable, and that you fasten
the switch tightly to the surface.
that the mounting location is stable, and that you fasten
the switch tightly to the surface.