Honeywell XYR 5000 LINE User Manual
(recommended in section 3.2.1) the value of the resistor should be a 120 Ohm ¼ watt
resistor.
resistor.
To terminate a Base Radio, place one end of the resistor in the open terminal block’s B
slot and place the other end of the resistor in the open terminal block’s A slot. Doing so
will place the resistor across the A and B wires, as needed. An example of this is shown
in Figure 3-10.
slot and place the other end of the resistor in the open terminal block’s A slot. Doing so
will place the resistor across the A and B wires, as needed. An example of this is shown
in Figure 3-10.
Figure 3-10 Example of Correct Termination Resistor Setup
3.2.8 Grounding the Base Radio
ts on your Base Radio, the Base Radio housing must
Possible grounded objects include:
•
The building’s metal frame-work
•
Any electrical conduit
•
A suitable grounding or lightning rod
3.2.9 High Gain Antenna
ilable for the Base Radio. This antenna generally doubles the
In order to assure safety requiremen
be grounded. We have provided a grounding screw located on the left side of the Base
Radio housing. To ground the Base Radio simply place a wire from the grounding screw
to a grounded object.
be grounded. We have provided a grounding screw located on the left side of the Base
Radio housing. To ground the Base Radio simply place a wire from the grounding screw
to a grounded object.
A high-gain antenna is ava
signal range of the Base Radio, but requires an installation in a general-purpose area.
signal range of the Base Radio, but requires an installation in a general-purpose area.
15