Intel 05-1832-002 User Manual

496

call progress analysis parameters 

 * DX_CAP

 * call progress analysis parameters

 */

typedef struct DX_CAP {

      unsigned short ca_nbrdna;         /* # of rings before no answer. */

      unsigned short ca_stdely;         /* Delay after dialing before analysis. */

      unsigned short ca_cnosig;         /* Duration of no signal time out delay. */

      unsigned short ca_lcdly;          /* Delay after dial before lc drop connect */

      unsigned short ca_lcdly1;         /* Delay after lc drop con. Before msg. */

      unsigned short ca_hedge;          /* Edge of answer to send connect message. */

      unsigned short ca_cnosil;         /* Initial continuous noise timeout delay. */

      unsigned short ca_lo1tola;        /* % acceptable pos. dev of short low sig. */

      unsigned short ca_lo1tolb;        /* % acceptable neg. dev of short low sig. */

      unsigned short ca_lo2tola;        /* % acceptable pos. dev of long low sig. */

      unsigned short ca_lo2tolb;        /* % acceptable neg. dev of long low sig. */

      unsigned short ca_hi1tola;        /* % acceptable pos. dev of high signal. */

      unsigned short ca_hi1tolb;        /* % acceptable neg. dev of high signal. */

      unsigned short ca_lo1bmax;        /* Maximum interval for shrt low for busy. */

      unsigned short ca_lo2bmax;        /* Maximum interval for long low for busy. */

      unsigned short ca_hi1bmax;        /* Maximum interval for 1st high for busy */

      unsigned short ca_nsbusy;         /* Num. of highs after nbrdna busy check. */

      unsigned short ca_logltch;        /* Silence deglitch duration. */

      unsigned short ca_higltch;        /* Non-silence deglitch duration. */

      unsigned short ca_lo1rmax;        /* Max. short low  dur. of double ring. */

      unsigned short ca_lo2rmin;        /* Min. long low  dur. of double ring. */

      unsigned short ca_intflg;         /* Operator intercept mode. */

      unsigned short ca_intfltr;        /* Minimum signal to qualify freq. detect. */

      unsigned short rfu1;              /* reserved for future use */

      unsigned short rfu2;              /* reserved for future use */

      unsigned short rfu3;              /* reserved for future use */

      unsigned short rfu4;              /* reserved for future use */

      unsigned short ca_hisiz;          /* Used to determine which lowmax to use. */

      unsigned short ca_alowmax;        /* Max. low before con. if high >hisize. */

      unsigned short ca_blowmax;        /* Max. low before con. if high <hisize. */

      unsigned short ca_nbrbeg;         /* Number of rings before analysis begins. */

      unsigned short ca_hi1ceil;        /* Maximum 2nd high dur. for a retrain. */

      unsigned short ca_lo1ceil;        /* Maximum 1st low dur. for a retrain. */

      unsigned short ca_lowerfrq;       /* Lower allowable frequency in Hz. */

      unsigned short ca_upperfrq;       /* Upper allowable frequency in Hz. */

      unsigned short ca_timefrq;        /* Total duration of good signal required. */

      unsigned short ca_rejctfrq;       /* Allowable % of bad signal. */

      unsigned short ca_maxansr;        /* Maximum duration of answer. */

      unsigned short ca_ansrdgl;        /* Silence deglitching value for answer. */

      unsigned short ca_mxtimefrq;      /* max time for 1st freq to remain in bounds */

      unsigned short ca_lower2frq;      /* lower bound for second frequency */

      unsigned short ca_upper2frq;      /* upper bound for second frequency */

      unsigned short ca_time2frq;       /* min time for 2nd freq to remains in bounds */

      unsigned short ca_mxtime2frq;     /* max time for 2nd freq to remain in bounds */

      unsigned short ca_lower3frq;      /* lower bound for third frequency */

      unsigned short ca_upper3frq;      /* upper bound for third frequency */

      unsigned short ca_time3frq;       /* min time for 3rd freq to remains in bounds */

      unsigned short ca_mxtime3frq;     /* max time for 3rd freq to remain in bounds */

      unsigned short ca_dtn_pres;       /* Length of a valid dial tone (def=1sec) */

      unsigned short ca_dtn_npres;      /* Max time to wait for dial tone (def=3sec)*/

      unsigned short ca_dtn_deboff;     /* The dialtone off debouncer (def=100msec) */

      unsigned short ca_pamd_failtime;  /* Wait for PAMD/PVD after cadence break (def=4s)*/

      unsigned short ca_pamd_minring;   /* min allowable ring duration (def=1.9sec)*/

      byte ca_pamd_spdval;              /* Set to 2 selects quick decision (def=1) */

      byte ca_pamd_qtemp;               /* The Qualification template to use for PAMD */

      unsigned short ca_noanswer;       /* time before no answer after 1st ring (def=30s) */

      unsigned short ca_maxintering;    /* Max inter ring delay before connect (8sec) */

} DX_CAP;