MicroNet Technology SP5100 User Manual
Note:
CD Panel of SP5100 IP Phone is operated manually by moving Í or Î on the keypad.
Pres
enter separate configuration menu. Press C to go back to the main menu.
L
s OK to
2.2 LCD
User can set the following 10 configurations manually by operating the commands
at have made for the SP5100 IP Phone, user has to do Reboot in
e selection 1→5 “Reboot”.
Configuration
displayed on LCD.
Note:
Any configurations th
th
Any configurations th
th
:
User must key in password to enter this menu, selections under this
ly be configured by
Note:
1. Pas
2. H.323 token password (please refer to item 9), default value is x. (Please press
2. H.323 token password (please refer to item 9), default value is x. (Please press
ANSFER button to switch as lowercase characters first.)
System Configuration (mandatory, protected by password)
z
Please Enter Password
command are all important ones, which can on
administrators.
administrators.
sword to enter System Configuration:
TR
3. If users forget password, please contact us for the specific password generated
according to MAC address of IP Phone.
1
There are ten sub-configurations included in Connect Configuration. It is
necessary for user to set it in order to run the SP5100 IP Phone correctly.
necessary for user to set it in order to run the SP5100 IP Phone correctly.
are one valid IP Address to meet your network
e
.xxx.xxx.xxx.
(2)
.
. Connect Configuration
In addition, user has to prep
environment. (Global public IP Address or Virtual IP Address)
environment. (Global public IP Address or Virtual IP Address)
(1) IP address
In this configuration mode, user presses the prepared IP Address on th
IP Phone keypad. Please input IP address as format: xxx
IP Phone keypad. Please input IP address as format: xxx
Subnet Mask:
User has to press the subnet mask IP Address on the IP Phone keypad
10