ZyXEL Communications P-2302R-P1C User Manual

Page of 145
 
 
P2302R-P1C Support Notes 
 
 
 
All contents Copyright 
 2007 ZyXEL Communications Corporation.   
112 
for key managements. Because the remote gateway checks this source port during connections, the port thus is 
not allowed to be changed.    
How do I setup my ZyXEL Device for routing IPsec packets over SUA?   
For  outgoing  IPsec  tunnels,  no  extra  setting  is  required.  For  forwarding  the  inbound  IPsec  ESP  tunnel,  A 
'Default' server set in menu 15 is required. It is because SUA makes your LAN appear as a single machine to 
the outside world. LAN users are invisible to outside users. So, to make an internal server for outside access, we 
must  specify  the  service  port  and  the  LAN  IP  of  this  server  in  Menu  15.  Thus  SUA  is  able  to  forward  the 
incoming packets to the requested service behind SUA and the outside users access the server using the ZyXEL 
Device's WAN IP address. So, we have to configure the internal IPsec as a default server (unspecified service 
port) in menu 15 when it acts a server gateway. 
VoIP FAQ 
 
What is Voice over IP?   
Voice over IP is an emerging technology based on open standards of IEEE, fundamentally the Internet Protocol, 
that allows voice data to travel across the Internet.    There are many method to used this technology, the most 
common and well known are SIP, and H.323. 
How does Voice over IP work? 
Basically VoIP is a technic to send voice information in digital form in discrete packets over digital network 
rather than by using traditional circuit switch (PSTN).    To do so we will need an analog to digital converter on 
sender side to translate the voice (analog signal) to digital than transmit it, and on the receiver end it will also 
need an analog  to digital converter to covert the digital  signal back to analog to the  person being called can 
heard the voice. 
Why use VoIP?   
Traditionally telephony carrier use circuit switching for carrying voice traffic.    As circuit switching is designed 
to carry voice and it does it very well.    Than why use IP for voice?    As broadband booms, and technology 
evolve.    People  now  want  to  communicate    through    various  way  not  just  voice  such  as  email,  instant 
messaging, video and so on.    Traditional telephony can not evolve as quickly as the demand and develop new 
feature on circuit switch takes much time and money.    IP is an already exist standard and many type of service 
already runs on IP, by using IP as a platform integrate service is now possible and low cost where traditional 
circuit may take long time to achieve.