Avaya 1040E User Manual

1. Form a small bend in the cable.

2. Thread the adapter cord through the channels in the stand.

To use PoE, your connected LAN must support PoE. A PoE-enabled LAN 
delivers power to your IP Deskphone over the CAT-5 network cable and 
an AC adapter is not required.

To use gigabit Ethernet, you must connect to the LAN through CAT-5e (or 
later) cables.

Use the following procedure to connect the handset to the IP Deskphone.

1. Connect the end of the handset cable with a short straight section to 

the handset. 

2. Connect the end of the handset cable with the long straight section, 

into the RJ-9 handset jack marked with the 

+

 symbol on the back of 

the IP Deskphone.

3. Form a small bend in the cable.

4. Thread the handset cord through the channels in the stand so that it 

exits behind the handset on the right side, using the handset cord exit 
in the stand base marked with the 

+

 symbol as shown in 

.

If you are connected to a PoE connection do not use the 
AC power adapter