Aastra Telecom 6867i SIP User Manual
Configuring Softkeys
41-001524-00 REV00 – 04.2014
99
Using the Paging Key
The following procedure describes the use of the Paging key on the IP phone. The procedure assumes you have already
configured the Paging key using the Aastra Web UI.
configured the Paging key using the Aastra Web UI.
9.
In the Value field, enter a multicast IP address and a port number for the Paging key. When you press this key, the
phone initiates an outgoing multicast RTP session to the specified address using the specified port. (For example,
239.0.1.15:10000).
239.0.1.15:10000).
Notes:
1. When you select Paging for the Type field, the Line field is disabled.
2. The Value field allows for one multicast address entry only.
1. When you select Paging for the Type field, the Line field is disabled.
2. The Value field allows for one multicast address entry only.
10.
To receive RTP steams for group paging, you must also configure the Paging Listen Addresses parameter at the
path, Basic Settings > Preferences > Group Paging RTP Settings. For more information about setting this parameter,
see
see
.
11.
Click Save Settings to save your changes
Notes:
• The recipient of a paging call can set a global DND to ignore any incoming pages.
• For incoming paging, the phone uses the Intercom configuration settings. The incoming page is dependant on the
• For incoming paging, the phone uses the Intercom configuration settings. The incoming page is dependant on the
Allow Barge In parameter setting and the idling/on call state.
IP Phone UI
1.
On the IP phone, press the softkey or expansion module key you configured for Paging.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays.
2.
Press the Drop key to end the multicast RTP session and return to the Home screen.
Note:
If you enable global DND on the phone, the incoming multicast RTP session is dropped.