Aastra Telecom 9112I User Manual

9112i IP Phone User Guide

3

Important! Do not unplug or 
remove power to the phone while 
it is checking or installing 
firmware. 

After the phone displays the 
Aastra splash screen or after 
downloading an update (if an 
update was available), the phone 
displays the Idle State screen:

The basic Idle State screen lists 
your name, extension, and today's 
date and time.  This screen is 
shown whenever your phone is not 
in use.

If your phone displays a  “No 
Service

” message without any 

extension or user name at the end 
of the start up sequence instead of 
the Idle State screen, this means 
your system administrator has not 
set up your extension correctly. 
Contact your system administrator 
for assistance.

The “No Service” or “Network 
disconnected

” prompt appears on 

the display and the telephone 
status light turns on when the 
phone is not properly connected to 
the network, or the account has not 
been configured by the 
administrator. The phone also 
displays the default time and date 

of 12:00am Jan. 1st, 2000. Check 
that the cables are tightly 
connected to the phone and to the 
wall jack. 
The phone should automatically 
detect when the connection is 
reconnected and will display the 
“Network Connected” prompt 
temporarily. If changes have been 
made to your phone settings, you 
may need to restart your phone. 
For more information on restarting 
your phone, see 

 on 

For more information about 
connecting your phone, refer to the 
Aastra SIP IP Phone 9112i 
Installation Guide under the 
section "Connecting to the 
Network and to Power". Check 
with your system administrator for 
assistance.

Pressing the 

I

 

button gives you a list of 
configurable options.
These options allow you to 
customize your phone settings.