Aastra Telecom 41-001343-02 User Manual

41-001343-02 REV04 – 05.2014

Paging Listen Addresses

Note:
This option can be set by both 
Users and Administrators.

paging group listening

Allows you to specify up to 5 listening multicast addresses to send/receive a Real 
Time Transport Protocol (RTP) stream to/from these pre-configured multicast 
addresses without involving SIP signaling. 

For more information on this feature, see 

.

Map Redial Key To

map redial key to

Sets the Redial key as a Speeddial key if a value is entered for this parameter. If you 
leave this parameter blank, the Redial key returns to its original functionality.

Note:
If you configure the Redial key for speeddialing on the 9480i CT or 6757i CT Base Sta-
tions, the Redial key on the 9480i CT and 6757i CT handsets retain their original func-
tionality. The Redial key on the handset is not configured for speed dial.

For more information on this feature, see 

 on 

.

Map Conf Key To

map conf key to

Sets the Conf key as a Speeddial key if a value is entered for this parameter. If you 
leave this parameter blank, the Conf key returns to its original functionality.

Note: 
If you configure the Conf key for speeddialing on the 9480i CT or 6757i CT Base Sta-
tions, the Conf key on the 9480i CT and 6757i CT handsets retain their original func-
tionality. The Conf key on the handset is not configured for speeddial.

For more information on this feature, see 

 on 

.

NA

map redial as dtmf

The “Redial” key remappings has the same behavior as the “Speed Dial” key when the 
phone is idle. During an active call the phone will send the custom number as DTMF 
using the phone configured DTMF method (inbound vs out-of-band RFC2833 vs SIP 
INFO). 

When a user presses the Redial key, the mapped number will be sent out as DTMF 
during an active call if the current “map redial key to” parameter is configured to a 
number and the “map redial as dtmf” parameter is set to “1”.

For more information on this feature, see 

 on 

.

NA

Map redial as conf

The “Redial” key remappings has the same behavior as the “Speed Dial” key when the 
phone is idle. During an active call the phone will send the custom number as DTMF 
using the phone configured DTMF method (inbound vs out-of-band RFC2833 vs SIP 
INFO). 

When a user presses the Conf key, the mapped number will be sent out as DTMF dur-
ing an active call if the current “map conf key to” parameter is configured to a 
number and “map conf as dtmf” parameter is set to “1”.

For more information on this feature, see 

 on 

.